mc²36 MKII Installation & Service Guide
Version: 1.0/1
42/56
5. Service Procedures
5.7.1
Adjusting the Bayserver Settings
The instructions below apply to a channel Bayserver. Note that the settings for a Gatesever can be adjusted in a
similar manner.
In both cases, the server is mounted inside the console frame. Therefore, you will need to lift a panel to access
its switches.
DO NOT
attempt to open the frame without first disconnecting the mains supply.
1.
Lift either the Fader or Central Panel in the bay you wish to adjust as described
, and secure it in
place using the
.
As soon as you lift the panel, you will see the Bayserver mounted inside the frame. Note that you do not need to
disconnect any cables.
The function of the Bayserver connectors and switches is explained on the sticker.
2.
Locate the S1 DIP switches and SW1 rotary switch. They can be accessed through a cut-out in the
protective cover plate (highlighted below):
3.
Set the
S1
DIP switches to the desired ON/OFF positions. Check the positions carefully as the switches
are mounted upside down when viewed from the front buffer.
4.
Set the
SW1
rotary switch to the required address.
5.
Replace the panel.
