mc²36 MKII Installation & Service Guide
Version: 1.0/1
35/56
5. Service Procedures
5.3
Replacing a Panel
Each control surface panel can be replaced without affecting the rest of the system. Channel bays are fitted
with one 16-fader panel per bay. The centre section is fitted with one central panel connecting to two circuit
boards.
DO NOT
attempt to open the frame without first disconnecting the mains supply.
1.
Remove the screws at the bottom of the panel using a T20 Torx driver.
The number of screws vary depending on the panel type: Fader Panels have three screws, while the Central
Panel has four.
You should remove the screws completely and place them carefully to one side, so that they do not fall into the
frame when the panel is lifted. The springs beneath the panel will raise it slightly from the frame.
2.
Gently lift the panel using your fingers:
