mc²36 MKII Installation & Service Guide
Version: 1.0/1
46/56
5. Service Procedures
3.
Disconnect all of the internal connectors from the front of the unit, taking note of where each one should
be fitted.
There are five RJ45 connectors on the left, and one RJ45 connector plus two power connectors on the right. The
function of each connector is explained on the stickers attached to the unit.
Internal View (from front)
Local IO Unit (internal connections)
4.
Now move to the rear of the console and loosen the local IO unit from the frame.
There are six screws, three on each side, holding the unit in place. Remove all of the screws using a T20 Torx
driver.
5.
Carefully remove the unit by sliding it out of the rear of the console frame. Take care that the frame does
not scrape the unit, and that the cables do not get caught.
6.
Slide the replacement into the console frame, taking care not to scratch the unit or get any cables
caught underneath.
7.
Replace the six screws to hold the unit in place (see step 4).
8.
Replace the internal connectors (see step 3).
9.
Replace all panels and the TFT display (see step 2).
10.
11.
When everything is back in place, re-connect the rear
MAINS
IEC power connectors, and power on.
Then check the functionality of the local IO.
