CELLULES DE REFROIDISSEMENT | NOTICE D’UTILISATION | FR
53
2 CONNEXION ÉLECTRIQUE ET EMPLACEMENT
2.1 PUISSANCE ÉLECTRIQUE
L’installation et les connexions électriques doivent être effectuées de façon professionnelle en fon
-
ction des normes électriques en vigueur. Ce travail sera effectué par un personnel compétent et
qualifié en vertu des règles de droit. La Société décline toute responsabilité découlant du défaut de
normes électriques en vigueur.
Voir le schéma de câblage de la Cellule de refroidissement (“APPENDICE - 5” Pag. 73)
Avant de relier électriquement la cellule, effectuer un nettoyage complet et précis de la cellule avec de l’eau
tiède et en utilisant un détergent neutre, non agressif, puis sécher avec un chiffon doux toutes les parties humi
-
des (attention avant de commencer, lisez la section “3 NETTOYAGE” Pag. 54).
Pour effectuer une connexion électrique, procédez ainsi:
•
Préparer un disjoncteur magnétothermique différentiel et assurez-vous que la fréquence / tension de ligne
corresponde à celle indiquée sur la plaque signalétique de la cellule (“APPENDICE - 2” Pag. 70)
•
Vérifiez la tension au point de capture, tous deux du nominal ±10% au moment où le compresseur.
•
Il est recommandé de monter un interrupteur bipolaire (ou quatre polaire) en coupant avec une ouver
-
ture de contact d’au moins 3 mm, en amont de la prise. Ce commutateur est nécessaire lorsque la charge
dépasse les 1000 watts ou lorsque la cellule est connectée directement, sans l’utilisation de la fiche. Le
disjoncteur doit être placé près de la cellule pour qu’il puisse être bien visible par le technicien en cas de
manutention.
Il est nécessaire que la section du cordon d’alimentation soit adéquate à la puissance absorbée par le groupe.
Il est obligatoire par la loi à l’échouement de l’installation, donc vous devez le connecter à une mise
à la terre efficace. Lorsque le cordon d’alimentation est endommagé, il doit être remplacé par un
personnel technique qualifié, afin d’éviter tout risque. Il est également recommandé de ne pas utiliser
électroménager dans les compartiments internes de la cellule.
•
Dans le cas où le compresseur est endommagé, celui-ci doit être remplacé exclusivement par du personnel
qualifié afin d’éviter tout risque. Il est recommandé d’éviter en cas d’échec de déconnecter l’entière installa
-
tion, et d’ utiliser un interrupteur coupe-circuit avec différentiel à haute sensibilité.
•
La fiche électrique de la cellule devra toujours être branchée directement à une prise fixe. Il est strictement
interdit de brancher la fiche électrique de la cellule à une prolonge et/ou bien un adaptateur.
2.2 MISE EN MARCHE
ATTENTION !
La première mise en marche de la cellule devra être effectuée par un personnel compétent et
qualifié.
Avant d’effectuer la mise en marche, vérifier que :
•
Ne pas avoir les mains humides ou mouillées
• Que les surfaces de la cellule soient sèches
• Que le sol soit parfaitement sec