SoundAdvisor Model 831C
Reviewing the Calibration Settings
5-3
•
5.2.2 Calibration Settings Tab
•
5.2.3 Calibration History Tab
•
5.2.4 Calibration Certification Tab
5.2.1 Calibrate Tab
When you perform a calibration using any of the known preamplifiers,
the SoundAdvisor updates the saved calibration information for that
preamplifier. If you install a different preamplifier, the SoundAdvisor
applies the previously saved calibration information. As long as the
same microphone is being used with that preamplifier, the calibration
is accurate.
5.2.2 Calibration Settings Tab
FIGURE 5-1
Calibration Settings
5.2.3 Calibration History Tab
Select a log entry and a calibration spectra box appears.
Select a calibrator.
The microphone type,
sensitivity, and peak
overload values are
available on this page
The under range and noise
floor capabilities.
Select the microphone that
is installed on your meter.
Other
: If the microphone
type is not found, or in
special cases, select
Other
and manually enter the
sensitivity.
If your calibrator has
unique values, use these
fields to manually enter
and save them.
Sensitivity data
prepopulates based on
your microphone. The
actual value is calculated
during calibration.
