SoundAdvisor Model 831C
Setting Up a Measurement With Measurement History
15-4
after the measurement according to this setting. For more
information, see
8.1 Setting Data File Storage Preferences
.
i.
Make a measurement.
Selecting Continuous Mode With Measurement History
a.
Select a
Daily
Auto-Store
interval.
At the end of the Auto-Store
interval,
the 831C saves the measurement record to a new,
incrementally-named, data file throughout the day based on the
Time (hh:mm:ss)
. Time is the time of day you want to begin
auto-storing measurement records.
TRY THIS
If you want to store a measurement record each hour of the day
beginning at 10:05, choose the following settings:
•
Auto-Store
: 1 hr
•
Time (hh:mm:ss)
: 10:05:00
If you start the measurement at 10:10, the measurement record stores
at 11:05, 12:05, and so forth. In this case, the initial measurement
history record has only 50 minutes of data, while all others contain the
full hour.
b.
If desired, select
Cal. Check,
and enter the
Time
of day it
should occur.
c.
Select
the
Enable Measurement History
checkbox, and enter a
duration (
hh:mm
) for each measurement record in the
Interval
Time
field.
Note:
Interval Time cannot be less than 00:01 (1
minute).
d.
If desired, select
Interval Time Sync
. This forces a new
measurement record to begin every
n
minutes (or hours), where
n
is the value of
Interval Time
.
• If you enter an
Interval Time
(hh:mm) value less than
0:01, the measurement interval syncs to the 1 min inter
-
val boundary.
• If you enter any other
Interval Time
(hh:mm) value of
01:00 or more, the measurement syncs to the hour.
e.
If you want to send a measurement interval exceedance alert,
select a checkbox in-line with
Alerts
.
