12: User Authentication
SLC™ Console Manager User Guide
171
3.
Assign rights to users. Each user is a member of a group that has a predefined user rights
associated with it. You can assign or remove additional rights to the individual user.
Enable for Dial-back
Select to grant a local user dial-back access. Users with dial-back access can
dial into the SLC console manager and enter their login and password. Once
the SLC unit authenticates them, the modem hangs up and dials them back.
Disabled by default.
Dial-back Number
The phone number the modem dials back on depends on this setting for the
device port. The user is either dialed back on a fixed number (specified on the
Device Port - Settings page), or on a number that is associated with the user’s
login (specified here).
Escape Sequence
A single character or a two-character sequence that causes the
SLC console
manager
to leave direct (interactive) mode. (To leave listen mode, press any
key.)
A suggested value is
Esc+A
(escape key, then uppercase "A" performed
quickly but not simultaneously). You would specify this value as
\
x1bA
, which
is hexadecimal (
\
x
) character 27 (
1B
) followed by an
A
.
This setting allows the user to terminate the
connect direct
command on
the command line interface when the endpoint of the command is deviceport,
tcp, or udp.
Break Sequence
A series of 1-10 characters users can enter on the command line interface to
send a break signal to the external device. A suggested value is
Esc+B
(escape key, then uppercase “B” performed quickly but not simultaneously).
You would specify this value as
\
x1bB
, which is hexadecimal (
\
x
) character 27
(
1B
) followed by a
B
.
Custom Menu
If custom menus have been created, you can assign a default custom menu to
the user. The custom menu will display at login.
Note:
In the Local Users table, if the menu assigned to a local user no longer
exists, it is marked with an asterisk (*).
Display Menu at Login
If custom menus have been created, select to enable the menu to display
when the user logs into the CLI.
Password /
Retype Password
When a user logs into the SLC console manager, the unit prompts for a
password (up to 64 characters). The sysadmin establishes that password
here.
Password Expires
If not selected, allows the user to keep a password indefinitely. If selected the
user keeps the password for a set period. (See the section,
for information on specifying the length of time
before the password expires.)
Allow Password Change
Select to allow the user to change password.
Change Password on
Next Login
Indicate whether the user must change the password at the next login.
Lock Account
Select to lock the account indefinitely.
Account Status
Displays the current account status:
Active
Locked
Locked (invalid logins)
Содержание SLC8
Страница 1: ...Part Number 900 449 Revision J July 2014 SLC Console Manager User Guide SLC8 SLC16 SLC32 SLC48...
Страница 95: ...8 Device Ports SLC Console Manager User Guide 95 Figure 8 4 Device Ports Settings...
Страница 150: ...10 USB Port SLC Console Manager User Guide 150 Figure 10 3 Devices USB Modem 3 Enter the following fields...
Страница 217: ...13 Maintenance SLC Console Manager User Guide 217 Figure 13 1 Maintenance Firmware Config...
