6: Basic Parameters
SLC™ Console Manager User Guide
64
2.
Enter the following:
Dynamic Routing
Static Routing
3.
Click the
Apply
button.
Note:
To display the routing table, status or specific report, see the section,
Equivalent Routing Commands
The following CLI commands correspond to the web page entries described above.
To configure static or dynamic routing:
set routing [parameters]
Parameters:
rip <enable|disable>
route <1-64> ipaddr <IP Address> mask <Netmask> gateway <IP Address>
static <enable|disable>
version <1|2|both>
Note:
To delete a static route, set the IP address, mask, and gateway parameters to
0.0.0.0.
To set the routing table to display IP addresses (disable) or the corresponding host names
(enable):
show routing [resolveip <enable|disable>] [email <Email Address>]
Note:
You can optionally email the displayed information.
Enable RIP
Select to enable
Dynamic Routing Information Protocol (RIP)
to assign routes
automatically. Disabled by default.
RIP Version
Select the
RIP
version. The default is
2
.
Enable Static
Routing
Select to assign the routes manually. The system administrator usually provides the
routes. Disabled by default.
To add a static route, enter the
IP Address
,
Subnet Mask
, and
Gateway
for the
route and click the
Add/Edit Route
button. The route displays in the Static Routes
table. You can add up to 64 static routes.
To edit a static route, select the radio button to the right of the route, change the
IP
Address
,
Subnet Mask
, and
Gateway
fields as desired, and click the
Add/Edit
Route
button.
To delete a static route, select the radio button to the right of the route and click the
Delete Route
button.
Содержание SLC8
Страница 1: ...Part Number 900 449 Revision J July 2014 SLC Console Manager User Guide SLC8 SLC16 SLC32 SLC48...
Страница 95: ...8 Device Ports SLC Console Manager User Guide 95 Figure 8 4 Device Ports Settings...
Страница 150: ...10 USB Port SLC Console Manager User Guide 150 Figure 10 3 Devices USB Modem 3 Enter the following fields...
Страница 217: ...13 Maintenance SLC Console Manager User Guide 217 Figure 13 1 Maintenance Firmware Config...
