Lantronix SLC8, Руководство пользователя

Страница: 231 / 351

13: Maintenance
SLC™ Console Manager User Guide 231
3. Click the Run Diagnostics button. The Diagnostics Report page displays.
Figure 13-8 Diagnostics Report
4. To email this report, follow the instructions in Emailing Logs and Reports (on page 236) .
Diagnostic Commands
The following CLI commands correspond to the web page entries described above.
To display the ARP table of IP address-to-hardware address mapping:
diag arp [email <Email Address>]
Ping Select to verify that the host is up and running. If selected, also do the following:

Enter a host name in the corresponding Hostname field
 Specify Ethernet Port (Both, Eth1 or Eth2)

Check IPv6 if... need text.
Send Packet This option sends an Ethernet packet out one of the Ethernet ports, mainly as a network
connectivity test. For UDP, the number of times the string is sent is equal to the number
of packets sent. For TCP, the number of times the string is sent may (or may not) be
equal to the number of packets sent, because TCP controls how data is packetized and
sent out. Enter the following:

Protocol: Select the type of packet to send ( TCP or UDP ).
 Hostname: Specify a host name or IPaddress of the host to send the packet to.

Port: Specify a TCP or UDP port number of the host to send the packet to.
 String: Enter a set of up to 64 characters. The string is encapsulated in the packet (so
you could use a network sniffer to track the packet and, by looking at its contents,
verify that it was sent).

Count: The count is the number of times the string is sent.
Loopback Specify loopback information:

Device Port
 Select either an Internal or External test
SLC Internals Select to display information on the internal memory, storage and processes of the SLC
unit.