SLC™ Console Manager User Guide
52
6:
Basic Parameters
This chapter explains how to set the following basic configuration settings for the SLC console
manager using the SLC web interface or the CLI:
Network parameters that determine how the SLC unit interacts with the attached network
Firewall and routing
Date and time
Note:
If you entered some of these settings using a Quick Setup procedure, you may
update them here. The features and functionality described in this chapter specific to PC
Card use are supported on SLC -02 part numbers. The features and functionality specific
to USB port use are supported on SLC -03 part numbers.
Requirements
If you assign a different IP address from the current one, it must be within a valid range, unique to
your network, and with the same subnet mask as your workstation.
To configure the unit, you need the following information:
Eth1
IP address:
________ - ________ - ________ - ________
Subnet mask:
________ - ________ - ________ - ________
Eth2
IP address (optional):
________ - ________ - ________ - ________
Subnet mask (optional): ________ - ________ - ________ - ________
Gateway:
___________ - ___________ - ___________ - ___________
DNS:
___________ - ___________ - ___________ - ___________
Содержание SLC8
Страница 1: ...Part Number 900 449 Revision J July 2014 SLC Console Manager User Guide SLC8 SLC16 SLC32 SLC48...
Страница 95: ...8 Device Ports SLC Console Manager User Guide 95 Figure 8 4 Device Ports Settings...
Страница 150: ...10 USB Port SLC Console Manager User Guide 150 Figure 10 3 Devices USB Modem 3 Enter the following fields...
Страница 217: ...13 Maintenance SLC Console Manager User Guide 217 Figure 13 1 Maintenance Firmware Config...
