Lanier AP4510, Руководство по установке

Страница: 308 / 424

Appendix
68
6
The following is an example for configuring an IP address of 192.168.15.16 on
Ethernet interface.
msh> ifconfig ether 192.168.15.16
The following is an example for configuring a subnet mask of 255.255.255.0 on
Ethernet interface.
msh> ifconfig ether netmask 255.255.255.0
Note
❒
This affects the configuration of the Network Interface Board of the IP ad-
dress that is used.
❒
To type an address using hexadecimal, prefix it by “0x”.
- - - -
Address
❖ ❖ ❖ ❖
Subnet Mask
A number used to mathematically “mask” or hide the IP address on the net-
work by eliminating those parts of the address that are alike for all the ma-
chines on the network.
❖ ❖ ❖ ❖
Default Gateway Address
A gateway is a connection or interchange point that connects two networks.
A gateway address is used as a gateway by the router or host computer .
Note
❒
To get the above addresses, contact your network administrator.
Access Control
Use the access command to view and configure access control. You can also
specify two or more access ranges.
❖
❖ ❖
❖
Reference
msh> access
❖
❖ ❖
❖
Configuration
msh> access
✩
range start-address end-address
•
✩
represents a target number between 1 and 5. (Up to five access ranges
can be registered and selected.)
Example: To specify accessible IP addresses between 192.168.0.10 and
192.168.0.20:
msh> access 1 range 192.168.0.10 192.168.0.20
Note
❒
The entry is invalid if the start address is greater than the end address.
❒
Up to five access ranges can be specified. The entry is invalid if the target
number is omitted.