Lanier AP4510, Руководство по установке

Страница: 150 / 424

Troubleshooting
76
5
Possible Cause Solutions
Is the Data In indicator
blinking or lit after starting
the print job?
If not blinking or lit, the data is not being sent to the printer.
❖ ❖ ❖ ❖
If the printer is connected to the computer using the in-
terface cable
Make sure the printer port settings are correct. For a parallel
port connection, port LPT1 or LPT2 should be set.
• Windows 95/98/Me
A
Click [ Start ] , point to [ Settings ] , and then click [ Printers ] .
B
Click to select the icon of the printer. Next, on the
[ File ]
menu, click [ Properties ] .
C
Click the [ Details ] tab.
D
Check the
[ Print to the following port ]
box to confirm that
the correct port is selected.
• Windows 2000
A
Click [ Start ] , point to [ Settings ] , and then click [ Printers ] .
B
Click to select the icon of the printer. Next, on the
[ File ]
menu, click
[ Properties ]
.
C
Click the [ Port ] tab.
D
Check the [ Print to the following port ] box to confirm that
the correct port is selected.
• Windows NT 4.0
A
Click [ Start ] , point to [ Settings ] , and then click [ Printers ] .
B
Click to select the icon of the printer. Next, on the [ File ]
menu, click
[ Properties ]
.
C
Click the [ Port ] tab.
D
Check the [ Print to the following port ] box to confirm that
the correct port is selected.
❖
❖ ❖
❖
Network Connection
Contact your network administrator.
Do you print via a net-
work? Confirm that the "Ethernet" setting is correct from the control pan-
el. See p.122 “Host Interface Menu”.
The setting governs the data transfer speed used by the Network
Interface Board. Three options are available:
• Auto (default)
• 100 Mbps
• 10 Mbps
Note
❒
For details about the appropriate setting to use on your net-
work, contact your network administrator.