Lampoassa VMI 6-17, Инструкция по использованию, установке и обслуживанию

Страница: 24 / 93

24
100% GEOTHERMAL HEAT
24
MAINTENANCE MANUAL
Use the button in the bottom left corner to return to the home screen. Use the arrow button in the bottom right corner to return to previous screen.
For instructions screen, press the ‘i’ button in the top right corner. In case of operation faults, an alarm button is displayed on the top bar.
Digital Output (NO)
1 Brine circuit 1 10
2 11
3 Alarm signal 12 Immersion heater 4
4 Compressor 1 13 Immersion heater 1
5 Condenser pump 1 14 Heating circuit pump 1
6 Magnetic valve 1 15 Heating circuit pump 2
7 Immersion heater 2 16 Heating circuit pump 3
8 Immersion heater 3 17
9 18 Pressure equalizing valve (Only 1-phase devices)
Analog inputs
This screen allows checking analog input statuses.
Analog Input (B)
1 Hot gas sensor 1 6 Circuit 1 outgoing temperature sensor
2 7 Circuit 2 outgoing temperature sensor
3 Boiler top part temperature sensor 8 Circuit 3 outgoing temperature / Me -
asurement of domestic hot water sensor
4 Boiler foot part temperature sensor 9 Inside temperature sensor
5 Outside temperatur sensor 10 Brine temperature sensor
Analog outputs
This screen allows checking analog output statuses.
Analog Output (Y)
1 Heating circuit 1 regulation motor 4 Heating circuit 3 regulation motor/
Adjusment of domestic hot water
2 Heating circuit 2 regulation motor 5 Speed regulation of brine pump
3 Analog immersion heater control
0-10V 6 Superheat valve regulation
5.4.3. Running information
This screen shows compressor’s current state.
5.4.4. Heat distribution circuit quantity
There may be from 1 to 3 heat distribution circuits, of which circuits 2 and
3 are optional. If three heat distribution circuits are in use, the domestic
water temperature limit function cannot be used at the same time.
5.4.5. Domestic hot water temperature limit
This screen allows activation of the domestic hot water temperature limit
and changing of the domestic hot water temperature sensor and the
related position valve connection location. The default setting is that the
temperature sensor is connected to analog input B8 and position valve to
analog output Y4.