laguna TS SERIES, Руководство пользователя

Страница: 42 / 78

42
Table dip in the middle.
Note only adjust the table in very small steps over a period of time. Cast iron is a
very brittle material and will break if over stressed.
1
/ Lay an engineer’s straight edge across the table.
2 / Using feeler gauges measure the gap under the straight edge.
3/ Remove the back panel to gain access to the underside of the machine.
4 / Loosen the table clamp bolt in the middle of the table and tighten the table adjustment
bolt [jack]. Only move the bolts a very small amount.
5/ Check the amount that you have moved the table using the straight edge and the feeler
gauges.
6 / Repeat until approximately ¾ of the dip is removed.
7 / Leave for a few days and re-check. The cast iron will continue to move.
8/ Repeat until the dip is removed.
Troubleshooting
Poor cut.
1
/ Dull blade. Change the blade.
2 / Bent tooth. Change the blade.
3 / Wrong type of blade for the job.
4/ Scoring not adjusted correctly. [If fitted]
Saw will not start.
1 / Check that the start switch is being depressed fully.
2 / Check that the electrical power cord is plugged into the power outlet.
3 / Check that the electrical supply is on [reset the breaker].
4 / With the power disconnected from the machine, check the wiring in the plug is correct.
Check that the rubber insulation is stripped enough, and is not causing a bad connection.
Check that all the screws are tight.
5 / With the power disconnected from the machine, check the wiring to the machine is
correct. Check that the rubber insulation is stripped enough and is not causing a bad
connection. Check that all the screws are tight
6 / Check that you have the correct power 220V not 110V
7 / Check the ground wire is wired correctly
The machine will not stop.
This is a very rare occurrence as the machine is designed to fail-safe. If it should occur
and you cannot fix the fault, seek professional assistance. The machine must be
disconnected from the power, and never run until the fault has been rectified.
1 / Stop switch faulty. Replace the stop switch.
2 / Internal contactor faulty. Replace the contactor.