laguna TS SERIES, Руководство пользователя

Страница: 15 / 78

15
Cleaning the machine.
Remove the rust protection grease with WD 40 or similar solvent
It is important that you remove all the grease and re lubricate with a Teflon bases
lubricant as Teflon has less tendency to attract sawdust and cause clogging. You should
also wax the table, as this also protects the cast iron from rust.
Leveling the machine.
Leveling bolt
The machine is provided with 4 leveling bolts. Move your machine to its final position,
and using a sprit level on the table, adjust the leveling bolts so that the table is level in
both directions. Ensure that the machine does not rock.
Switch box shown with optional scoring
switch
Vertical control handle
The start / stop switches are located on the side of the machine next to the blade vertical
control handle. The knob in the center of the control handle, is a lock that locks the blade
in the vertical position selected.
Angle control handle
The handle on the front of the machine, controls the angle of the saw blade. The angle
read out is on the side of the machine by the vertical control knob. When moving the
blade to an angle, the yellow-hinged dust plate
MUST be closed. Damage may occur if
the yellow hinge plate is not closed.