laguna TS SERIES, Руководство пользователя

Страница: 11 / 78

11
Sliding table.
The sliding table is manufactured from heavy aluminum extrusion. The table is supported
by ball bearings that roll on polished round steel rods. The clearance between the ball
bearings and the polished round steel guide rods is adjustable. The advantage of the
bearing system is that there is only point contact between the balls and the rods, which
virtually eliminate the problem of dirt, building up and the sliding table will remain
accurate for many years. When wear
takes place the polished round steel rods can be
rotated and present a new surface to the ball bearing.
Miter gauge [Optional].
The miter gauge has a cast iron body with an aluminum fence. The miter gauge is
adjustable for angle and has dowel holes every 15 degrees for quick accurate setting. The
fence is movable in relation to the body so that you can adjust it to suite the job.
Miter fence TSS.
The miter fence is manufactured from cast iron and heavy-duty gauge aluminum
extrusion. It is supplied with a flip stop and a job clamp. It can be set at any angle and has
an adjustable 90-degree flip stop that is fitted to the side of the sliding table.
Mobility kit [Optional]
The mobility kit is easy to fit and the machine is located directly on the floor when the
mobility kit is not in use.
Scoring unit [optional]
The scoring unit can be purchased with the saw or fitted as an option later. The scoring
unit has a separate motor and is adjustable vertically and horizontally. All machines are
supplied with locating / fixing holes and faces machined to accept a scoring unit.
The machine should never be started with both motors engaged . The main motor
must be started and when at full steed then the scoring motor started. If both motors are
started at the same time excessive load is put on to the contactor and it will burn out.