laguna TS SERIES, Руководство пользователя

Страница: 23 / 78

23
13 / Hold the work piece firmly against the table. Do not attempt to saw stock that does
not have a flat surface facing down.
14 / Use a push stick at the end of a cut. This is the most dangerous time, because the cut
is complete and the blade is exposed. Push sticks are commercially available.
15 / Hold the wood firmly, and feed it into the blade at a moderate speed.
16 / Turn off the machine if you have to back the material out of an uncompleted or
jammed cut.
Machine test
Now is the time to test the machine.
Note . Never start the main saw motor and the scoring motor at the same time. It will
damage the magnetic contactor. Always start the main motor and when running at full
speed then start the scoring motor.
Stop switch
Optional Scoring switch
1 / Check that the machine is clear of all tools, and other loose objects.
2 / Check that all the adjusting and locking handles are tight.
3 / Check that there is no blade fitted, it is far safer to test the machine with out a blade
fitted.
4 / Start the machine by pressing the green start switch.
5 /. Saw arbor is now turning.
6 /. Now is the time to check that the safety switch is functioning correctly before you fit a
blade.
7 / With the machine running [no blade fitted] operate the red stop switch by pressing
towards the machine. The motor should have the power removed and slow down.
8 / If the safety switch fails to operate correctly do not use the machine until the fault has
been corrected.
Before you cut any wood read the safety rules at the front of this manual