laguna TS SERIES, Руководство пользователя

Страница: 25 / 78

25
Lublicate the non painted surfaces of the tube with wax or teflon lubricant. This will
ensure that the fence runs smoothly and that the tube is protected from rust.
Adjusting the fence vertically parallel to the saw table.
Adjusting Wrench
Squaring the fence
The angle tube assembly will have to be adjusted vertically to ensure that the gap
between the fence and the table is even along its travel. With the fence close to the blade
place a piece of material 1/16” thick on the table under the fence close to the locking
handle. Loosen the screws that attach the angle to the table, leaving the screw furthest
away from the fence tight. Bring the tube angle assembly up so that it touches the [2]
pads on the underside of the fence, and then tighten the screw close to the fence. Move
the fence to the end of the saw table and repeat. Once the fence is set, tighten all the angle
clamping screws.
Note . It is not critical that the gap under the fence is parallel. It is critical that the rub pad
at the end of the fence is the only part of the fence that touches the table.
Drill through the holes in the steel angle and attach the table to the angle.
You will have to remove the guide tube to drill the holes and then refit it.
Squaring the fence.
A simple way to align the fence is to put a straight edge in the miter slot and align the
fence to the straight edge. If adjustment is required, [2] adjustment screws are provided.
When using the adjustment screws, only move them a small amount at a time. A small
amount of movement on the screw gives a large amount of movement on the fence.
Squaring the fence