12
Where to locate your machine.
Before you remove your machine from the pallet select the area where you will use your
machine. There are no hard and fast rules for its location but below are a few guidelines.
1
/ There should be an area at the front and back of the machine suitable for the length of
wood that you will be cutting.
2
/ Adequate lighting. The better the lighting the more accurate and safely you will be able
to work
3
/ Solid floor. You should select a solid flat floor, preferably concrete or something
similar.
4
/ Close to power source and dust collection.
5
/ Allow an area for the storage of blanks and cut jobs.
Unpacking your machine.
To unpack your machine you will need tin snips, knife and a wrench.
1
/ Using the tin snips, cut the banding that is securing the packing box [If fitted].
WARNING: EXTREME CAUTION MUST BE USED BECAUSE THE BANDING
WILL SPRING AND COULD CAUSE INJURY.
2
/ Dismantle the box or remove the row of screws around the base of the box and lift the
box off the pallet. You will need two people to lift the box off the pallet.
3
/Using the knife cut the plastic wrap. The extension table, fence and accessories that
were ordered are in the box.
4
/ Remove the base mounting bolts that secure the machine to the base of the box.
5
/ It is recommended that the machine be removed from the pallet by lifting it with a
hoist or forklift. Remove the pallet and lower to the floor. [To lift with a hoist, four lifting
hooks are provided that fit into the holes at the bottom of the body.]
The machine can be lifted using a forklift truck, sliding it onto the forks or by using a
"SLING" with a lifting capability of 2000 Kg [4400lb]
If no lifting device is available you can fit the mobility kit [if ordered] build a temporary
ramp and roll the machine off the pallet.
Note
The machine is heavy; ensure that you have sufficient people.
Note
: If you have any doubt about the described procedure seek professional assistance.
Do not attempt any procedure that you feel is unsafe or that you do not have the physical
capability of achieving.
Содержание TS SERIES
