laguna TS SERIES, Руководство пользователя

Страница: 30 / 78

30
Optional miter gauge.
Jack screw Clamp screw
Optional miter gauge Dowel pin
The miter gauge has an adjustable pointer; it also has a dowel pin that locks the miter
gauge at 15-degree positions. The fence can be moved to different positions on the miter
gauge to suit the job that you are doing. The fence is cut at 45 degrees at the end to
enable the job to be supported close to the blade when cutting at 45 degrees.
To adjust the pointer, loosen the clamp screw, adjust the pointer and re tighten the clamp
screw.
To move the fence to a different position on the miter gauge, loosen the clamp screws.
Slide the fence to the required position, and re clamp in position.
If you need to move the fence so that the steel clamp block is not supported by the fence,
a jackscrew is provided to hold the steel block parallel.
Optional scoring unit.
Parts you will receive
Scoring casting disassembled
The optional scoring can be fitted as follows
Disassemble the scoring casting as shown.
Scoring body disassembled