laguna TS SERIES, Руководство пользователя

Страница: 38 / 78

38
A second way to check is to measure the distance between the miter slot and the slot in
the sliding table. The miter slot is parallel with the saw blade and is a good reference
point.
If adjustment is needed proceed as follows.
1 / Loosen three of the lower clamp nuts. Do not adjust the top bolts , as this will affect
the level of the sliding table. Leave one of the bolts that is close to the main table tight.
2 / Swivel the table towards or away from the main table depending on the direction of the
adjustment that is needed. Note only do very small adjustments.
3 / Tighten the three loosened bolts and re check.
4 / If readjustment is necessary repeat the procedure.
Sliding table adjustment for bearing / steel rod clearance.
Screw “X”
Screw “Y”
The sliding table mechanism is designed with 8 ground steel rods, ball bearings run
between the steel rods. The table comes factory set but if there is excessive side
movement adjustment can be made as follows.
1 / Extend the table to one end. The ball carriage will be at the opposite end.
2 / Move the table side to side to check for excessive movement.
3 / Loosen the allen screw [X] and tighten allen screw [Y]. The screws must be adjusted
in pairs, and 2 pairs of screws cover the range of the ball carriage.
Note . The screws should be adjusted in small steps as damage could be caused.
Note . That the [X] screws must be tight before you check for side movement.
4 / Move the table so that the next two pairs of screws are covered by the ball carriage,
and repeat the adjustment procedure.
5 / Continue until all the screws have been adjusted.