Laguna Tools SuperMax SuperBrush 24 x 2, Руководство пользователя

Страница: 33 / 48

LAGUNATOOLS.COM 33
Machine
Symptom Possible Cause Solution
Brush height adjustment works
improperly.
1. Improper adjustment
of height control.
Readjust height control.
Knocking sound while running. 1. V-belt worn.
2. Pulleys wobbling or out
of round.
3. Set screws loose in pulley
or bearing.
4. Bearing worn.
Replace V-belt.
Tighten set screws
or replace pulley.
Retighten set screws.
Replace bearing.
Sniping of stock (gouging near 1. Inadequate support of stock. Use roller stands to
support stock.
end).
2. Conveyor drive or driven Readjust rollers.
rollers higher than conveyor
bed.
Burning of stock or melting of finish. 1. Feed rate too slow
2. Excessive depth of cut.
Increase feed rate.
Reduce depth of cut,
decrease brush
RPM.
Gouging of stock. 1. Conveyor belt is too loose.
2. Excessive depth of cut.
3. Stock slipping on
conveyor due to lack of
contact.
Adjust belt tension.
Reduce depth of cut,
decrease brush RPM.
Use alternate feeding
procedure .