Laguna Tools SuperMax SuperBrush 24 x 2, Руководство пользователя, Страница: 18 / 48

LAGUNATOOLS.COM 18
5. Check tightness of all hardware.
NOTE: shipping can loosen nuts, bolts and set screws.
6. Remove shipping arbors (2) from brush machine, Fig. 7;
A. Loosen drive belt by raising motor with motor tension handle on top
of the column near drive belt.
B. Slide drive belt off pulley.
C. Remove two bolts from each bearing.
D. Remove shipping arbor from brush sander.
E. Loosen set screws in each bearing and driven pulley.
F. Slide pulley and bearings off shaft for use with the brush heads.
F
igure 7A & B: Shipping Arbor and Bearings
7. Installing brush heads (same process for both brush heads);
A. Install brush heads (if not already installed) by removing brush
head from shipping box.
B. Slide one bearing (from Shipping Arbor) on each end of the brush
shaft. Do not yet tighten the set screws for the bearing collar,
Fig. 7B.
C. Place the shaft key into the key slot of the drive shaft of the brush
head.
D. Slide the pulley, Fig. 7A (from Shipping Arbor) onto the drive shaft
over the key.
E. Raise the main motor by using the hand crank, Fig. 7A, at the top of
the column to lift the motor.
Mounting Bolts (2)
Set Screws (2)
Hand Crank, motor
Pulley
Shipping
Arbor
Bearings (2)