Lagler TRIO 900.65.00.100, Руководство по эксплуатации, Страница: 58 / 80

TRIO 01.04.2015
English / Englisch
9.3 THE MACHINE RUNS BUT HAS NO OR VERY
LITTLE SANDING POWER CAPACITY
• Sanding plates: The sanding medium is incorrect or dull and
must be replaced.
Section 5.3, Changing the sanding media
• Milling discs: The indexable inserts are dull or damaged and
must be turned or replaced.
Section 5.4, Working with milling discs
• The sanding plates or milling discs are not mounted properly
and must be fixed correctly.
Section 5.2, Changing the sanding plates
• At low temperatures: The machine is too cold and must be
heated up to room temperature in a warm room.
• Cables which are too long or too thin are used for the
electrical connection:
- The power cables have a total length of more than 20 m
(790”).
- The power cables have wire cross-sections which are too
small:
at mains voltage 220 V or 230 V are the wire cross-sections
smaller than 2.5 mm² (0.0039 sq.in.),
at mains voltage 400 V are the wire cross-sections smaller
than 1.5 mm² (0.0023 sq.in.).
This causes of faults lead to a loss of power and are not
allowed for safety reasons!
• The electrical network is not providing sufficient voltage
(undervoltage). Use a transformer if necessary (e.g. LÄGLER ®
part number 708.00.00.100 for 230 V).
• The tooth belt is not tight enough and must be tightened a
bit.
Section 7.4, Changing the tooth belt
CAUSES OF FAULTS
9
58