LaCie 131018 - StorView Snapshot - Mac, Руководство пользователя

Страница: 196 / 214

StorView RAID Module
188
It can be seen that the more sub-arrays used, the more likely it is for a Full Stripe Write to occur, and
hence the higher the performance. It is recommended to use either four or five drives in a sub-array, for
best performance. On the following page the figure shows that even with 15 drives, it is still possible to
perform Full Stripe Writes, by clustering together 4 chunks of data.
A.5 Multiple Drive Failures
In a configuration with multiple sub-arrays, it is possible for the array to sustain multiple drive failures,
provided that there is only one failure in each sub-array.
A.5.1 Faster Rebuild
A rebuild operation must read data and calculate parity from all the remaining drives in the RAID set. If
multiple sub-arrays are used, this means that it is only necessary to read the data from the remaining
drives in the sub-array, not all of the drives in the array. This increases both the rebuild speed and the
speed of access to missing data, which also has to be recreated from the remaining drives.
A.6 Summary
In summary, for maximum performance, it is recommended to use four or five drives in a sub-array. If
there are more than five drives in a sub-array, it is better to use a smaller chunk size, say 64K or 128K,
as this will lead to more Full Stripe Writes.
Figure A–4 Distribution of Data and Parity in a RAID 5 with Fifteen Drives and Three Sub-Arrays