Program Mode and the Program Editor
The Program Editor—Pages
6-11
EditProg:LAYER|||||||||||||<>Layer:1/1||
LoKey|:
C|0|
|DlyCtl:OFF|||||||SusPdl:On||
HiKey|:C|8||MinDly:0.000s||||SosPdl:On||
LoVel|:ppp||MaxDly:0.000s||||FrzPdl:On||
HiVel|:fff||Enable:ON||||||||IgnRel:Off|
PBMode:All||S:Norm|64||127|||ThrAtt:Off|
Trig||
:
Norm|O
p
aque:O
f
f|||||
|
|TilDe
c
:Off|
<more|
|
ALG|||
|
LAYER|
|
KEYMAP
|
PITCH|
|
more>
PARAMETER
RANGE OF VALUES
DEFAULT
LOW KEY
C -1 to G 9
C 0
HIGH KEY
C -1 to G 9
C 8
LOW VELOCITY
ppp to fff
ppp
HIGH VELOCITY
ppp to fff
fff
PITCH BEND MODE
Off, Key, All
All
TRIG
Normal, Reversed
Normal
DELAY CONTROL
Control Source list
OFF
MINIMUM DELAY
0 to 25 seconds
0
MAXIMUM DELAY
0 to 25 seconds
0
LAYER ENABLE
Control Source list
ON
ENABLE SENSE
Normal, Reversed / Min. / Max.
Normal / 64 / 127
OPAQUE LAYER
Off, On
Off
SUSTAIN PEDAL
Off, On
On
SOSTENUTO PEDAL
Off, On
On
FREEZE PEDAL
Off, On
On
IGNORE RELEASE
Off, On
Off
HOLD THROUGH ATTACK
Off, On
Off
HOLD UNTIL SUSTAIN
Off, On
Off
Low Key (LoKey)
This sets the lowest active note for the current layer. This parameterÕs value cannot be set
higher than the value for HiKey. The standard MIDI key range is C -1ÑG 9 (0-127). Middle C is
C 4 (ISP).
High Key (HiKey)
Here you set the highest active note for the current layer. This parameterÕs value cannot be set
lower than the value for LoKey.
Low Velocity (LoVel)
With this parameter you deÞne the lowest attack velocity at which the layer will be enabled
(generate a sound). The values for this parameter and the next are expressed in the standard
musical dynamics markings, similar to the values available for the velocity maps. Attack
velocities that are below this velocity threshold will not trigger notes. If you set this
parameterÕs value higher than the HiVel value, the layer will not play at all.
High Velocity (HiVel)
Similarly, this will set the highest attack velocity at which the layer will be enabled. Attack
velocities above this velocity will not trigger notes in this layer.
Pitch Bend Mode (PBMode)
This determines how Pitch bend control messages will affect the current layer. A value of ÒAllÓ
bends all notes that are on when the Pitch bend message is generated. A value of ÒKeyÓ bends
Содержание K2500RS
