FUNS
The FUN Equations
16-3
youÕll need to go to the LAYER page and set the PBMode parameter to a value of Off to keep
Pitch Wheel messages from interfering with the test model.
Now select the Function parameter, and scroll through the list of equations. Move your MIDI
controllerÕs Mod Wheel and Data slider as you play, and listen to their effects. Actually
listening to the various effects while reading the explanations below will help your
understanding. In the model weÕve set up here,
inputs a
and
b
are both unipolar. The effect of
each equation will differ depending on the type of controls you assign to the inputs. There are
four possible combinations: both inputs unipolar; both inputs bipolar;
input a
unipolar with
input b
bipolar;
input a
bipolar with
input b
unipolar.
The FUN Equations
In this section weÕll describe how each of the FUN equations works. In some cases, a small
graph will accompany the explanation. HereÕs how to interpret the graphs.
Each graph shows a curve illustrating the effect of the equations on the input signals. The
horizontal axis represents the possible values of the input to the FUN (the combined control
signals of
inputs a
and
b
). The vertical axis represents the possible values of the FUNÕs output
signal. The four elements in the diagram below show you how to read these graphs:
a
the curve representing the effect of the FUNÕs equation on every possible input value
b
one point on that curve, representing a single input value and the corresponding output
value generated by the FUNÕs equation
c
the input value represented by the point
d
the output value represented by the point
For any point on the equationÕs curve, you can determine the input value by tracing a line from
the point to the horizontal axis. Similarly, you can determine the output value by tracing a line
from the point to the vertical axis. For the point shown in the example above, the combined
values of the control signals of
inputs a
and
b
equal about -.5, which translates to an output
value of +.5. An input value of -1 gives an output value of 0, as do input values of 0 and +1. An
input value of +.5 gives an output value of -.5.
-1
-1
1
1
•
a
d
c
b
Содержание K2500RS
