KUHN MERGE MAXX 950, Руководство оператора

Страница: 53 / 124

6. - Putting into service
MERGE MAXX 950
53
KN233BGB_C
Merger
The direction of rotation is shown on a decal.
- Separate the two half PTO shafts and connect
them to the machine's input shaft and to the tractor
PTO stub.
- Check the length of the PTO shaft:
• Check the maximum overlap when tractor and
machine PTO stubs are in line.
• When the PTO shaft is in its maximum overlap
position (retracted), tubes should not butt against
the yokes. Keep a minimum safety travel L of
10 mm (0.4’’).
• When extended to the maximum, the tube
overlap must not be below 250 mm (10’’).
If this is not the case:
- Mark length (H) to cut when the transmission is the
maximum overlap position.
- Shorten the guard tubes and the transmission
tubes by the same length.
- Bevel and clean the tubes.
- Grease the inside of the outer tube.
750
min
1
650
min
1
K9C311TL 0
1000
min
1
850
min
1
K9C312TL 0
H
L