KUHN MDS 55, Руководство оператора

Страница: 35 / 81

Erreur ! Style non défini. Erreur ! Style non défini.
33
6.5 Setting application rates on the
MDS 55 K / R / D MDS 65 K / R / D MDS 85 K / R / D
MDS 735 K / R / D and MDS 935 K / R / D
A potential crushing and amputation hazard exists when carrying out
adjustments or other work on the fertiliser spreader.
Rotating parts (e.g. spreading discs, pto shaft) and remote controlled machine
elements (e.g. adjusting lever, metering slides) can cause serious injuries.
•
Before carrying out adjustments or other general work such as maintenance
or cleaning, disengage the pto drive, stop engine and remove the ignition
key.
•
Wait until all rotating parts have come to a standstill before approaching the
machine.
An application rate with its corresponding position on the scale segment is se-
lected from the calibration charts, according to the desired forward speed. The
stop on the segment is positioned so that its edge is aligned to the position se-
lected. (Marked edge (2) aligned to the selected position.)
Both left- and right-hand side stops must be equally adjusted to the same scale
position and securely locked in place.
Closing the cut-off valves (only valid for single acting metering slide
control)
Close the shut-off valves before all transport journeys and before parking or
disconnecting the unit, as most valves are not entirely oil tight, thus allowing the
spring tension of the hydraulic metering control to overcome oil pressure, resul-
ting in the metering slides opening and fertiliser escaping from the hopper.
WARNING
A
TTENTION