- 32 -
6) LONG POTATO BLADES
(only for HR 5002 DR / 6002 DR)
These blades allow for deep work in ground which is light and loose. They are solely intended for potato cultivation.
They are available from spare parts with the following reference numbers :
Right blade :
part no. 525 524 10
Left blade :
part no. 525 525 10.
7) HARD COATED PACKER ROLLER SCRAPER PLATES
These scraper plates, which are more resistant to wear and tear, are available as replacement parts under
part no. 525 600 10
.
8) NYLON CLEANING PLATES FOR PACKER ROLLER SCRAPERS
Part No. 525 702 00
for the packer roller
Part No. 525 923 00
for the maxipacker roller
These cleaning plates are made from a supple synthetic
material which enables them to be slightly pre
compressed against the roller for better cleaning
action.
a) Installation and adjustment (photo 31) :
The nylon cleaning craper plates (R) are to be placed :
- between two new standard steel scraper plates (S)
(525 321 30) for standard packer rollers by using a
longer screw (V) (part No 500 073 00),
- between two non hardcoated steel scraper plates
(S) (525 989 00) on maxipacker rollers by using a
longer screw (V) (part No 800 312 40).
Allow the nylon cleaning plate (R) to stick out of the carrier plates (S) by 10 mm and press it slightly against the
roller so that its leading edge is in contact with the roller segment across its full width. Rotate the roller one complete
turn to check that there is no gap between roller and nylon cleaning plate. Re-adjust the plate if this is not the case.
Also check that the upper carrier plate is set parallel to the roller segment and does not come into contact
with it.
b) Use :
The nylon cleaning plate is particularly recommended for light, loamy or chalky grounds with little crop residue or
stones. A correct cleaning plate adjustment results in a clean and shiny roller area across the full width of the
cleaning plates.
Soil deposit on the roller will result in premature cleaning plate wear. Readjust them quickly. The cleaning plate is
reversible for increased service life.
9) P.T.O. SHAFTS
Depending on the profile of the tractor PTO shaft end, the PTO shaft can be ordered with the following tractor end
yokes :
- diameter 1 3/8" - 21
splines
:
part no. 4600 603
- diameter 1 3/4" -
6
splines
:
part no. 4600 604
- diameter 1 3/4" -
20
splines
:
part no. 4600 605.
