- 23 -
TRANSPORT
BEFORE FOLDING THE MACHINE
INTO TRANSPORT POSITION, MAKE
SURE NOBODY IS IN THE PIVOTING
AREA OF THE HALF-HARROWS.
In order to change the machine from working position
(photo 16) into transport position proceed as follows :
- lift the machine clear off the ground with the tractor’s
3-point lift,
- make sure no one is in the manoeuvring zone,
- if the machine is equiped with a rear hydraulic
attachment, make sure that all the dispositions
concerning this attachment and the folding of the
machine have been taken (see page 29),
- activate the two half-harrow lifting cylinder (V) until
the mecanical latches (M) are engaged (photo 17).
Never engage the PTO drive when the
two half-harrows are in transport po-
sition.
In transport position the machine must
be equiped with 2 signaling panels,
rear lights and reflectors, the two
half-harrows covering the rear lights
of the tractor (photo 18).
In this position, the overall machine width is of 2.65m
with the rollers in the standard position, and 2.48 m with
the rollers in an upward position [pin (T) in hole (O),
photo 9, page 17].
The total transport hight of the ma-
chine measured from the ground must
not exceed 4m (maximum height
allowed by the highway code).
16
