- 37 -
Noisy drive when lifting
Top link of 3-point hitch badly
Position the top link parallel
the machine
positioned/adjusted
to the lower lift arms (page 13)
Excessive lifting height
Reduce lifting height
Noisy drive during work
Machine is tilted to the front
Lengthen or shorten top link to
or rear
set the machine horizontally
during work. (The tractor PTO
shaft end and machine input shaft
must be parallel to each other
(page 13)
Machine insufficiently stabilized
Tighten the tractor's anti-sway
and moves from side to side
stabilisers
Too much power needed
Working depth too deep
Adjust the machine to a higher
setting by means of the rollers.
Make sure it is set no deeper
than necessary.
Rotor speed (rotational frequency)
Reduce rotor speed (rotational
is too high
frequency) at the gearbox (see
optional sets of matching gears on
page 16)
Forward speed too high
Reduce forward speed
Incorrect setting of the rear
Adjust levelling bars to a higher
levelling bars
setting
Tilth produced is too coarse
Considerable build up of long
Eliminate the plant residues
plant residues around the blades
Forward speed too high
Reduce forward speed
Insufficent rotor speed (rotational
Increase the rotor speed (rotational
frequency)
frequency) at the gearbox (see
optional sets of matching gears on
page 16)
No levelling bars
Install the levelling bars prefera-
bly towards the rear (page 27)
CAUSE
REMEDY
PROBLEM
TROUBLE SHOOTING
