Kugelmann Maschinenbau DUPLEX, Руководство по эксплуатации

Страница: 43 / 60

Chapter 05 4
3
www.kugelmann.com
Now you set the spread quantity through the control and control it according to k-tronic instructions.
If the spreading material is changed we recommend to definitely check the settings.
Setting of the spreading equipment
Refined salt and rock salt with standard density are set in the control and must be dry. All safety measure have
been taken. De-icing salt has been filled into the chambers, the control system is ready for operation. The
hydraulic drive or the respective other drive as well as the all-round beacon have been switched on.
The spread pattern often depends on the quality of the spreading material.
Is the height of the spreading disc is changed, so is the spreading width and the spread
pattern. Bigger wheels of a higher platform, for example, can cause this.
Adjustment of spreaded quantity
The spreading unit is folded up, the sensor in the chute assures that the spreading disc is turned off.
Pay attention to the warning notice. Do not grab into the metering screw, there is danger of severe injuries.
Put an empty bucket of at least 30 litre capacity under the outlet of the meterng screw. Furthermore, a scale for
determining the precise weight of the spreaded de-icing salt is necessary.
Remove the brine hose from the spreading disc and hold it into a separate collecting container (bucket). Proceed
as with the metering screw.
The spreaded quantity has to be set at each outlet and for each spreaded material.
Subject to changes
English