Kugelmann Maschinenbau DUPLEX, Руководство по эксплуатации

Страница: 28 / 60

E
ngl
is
h
28
Mounting, disassembly of spreader
With hangers
The mountable spreader can also be moved with hangers. The following has to be kept in mind.
Carrying load, danger for health and life! Do not stand under suspended loads!
Pay attention to the carrying capacity of the hanger, possibly consider partial loading.
Most suitable for this purpose are heavy-duty straps,
which, of course, must have the required carrying capacty.
Always lift spreader with a shackle.
Chain hangers with correspinding chain protection to avoid damage
to the hull can also be used. Only secure at the intended eyes at
the top and bottom, see picture.
Pay attention to sufficient length of the heavy-duty straps or chains,
respectively, and take into consideration thatconsiderably greater forces
are created through angled pulling or deflection above the container.
The diagram at slip shows you the maximum load. Make sure that
the carrying capacity of the heavy-duty lashes or chain hangers are
sufficient. Create safety reserves.
The point of gravity of the spreader is, viewed in driving direction
behind the middle of the hull.
In this position the spreader can be lifted in the horizontal.
Fixing on the loading platform with lashing straps.When mounting with
intermediate frame (spider) fixing is done with eyes. The 4 claws of the intermediate frame have to fit into the balls
of the vehicle frame.
The telescopic cylinder on the platform has to be secured against extension when
mountng is done with a spider.
Hydraulic hoses, control cables are to be connected as described in the text „mounting with tripod“, assure power
supply for control. Mounting is complete.
For mounting of a spreader which is driven via p.t.o. hydraulic pump or a separate drive motor see section
„mounting of a spreader with tripod“ chapter 04, page 28.
Subject to changes
E