Kubota ,RCK60B-23BX, Руководство по ремонту

Страница: 74 / 436

IMPORTANT
• To prevent serious damage to the engine, use
only a KUBOTA genuine filter.
1. Remove the oil filter.
2. Put a film of the clean engine oil on the rubber seal
of the new filter.
3. Tighten the filter quickly until it contacts the
mounting surface.
4. Tighten filter by hand an additional 1/2 turn only.
5. After the new filter has been replaced, the engine
oil normally decreases a little. Make sure that the
engine oil does not leak through the seal and be
sure to check the oil level on the dipstick.
6. Fill the engine with the engine oil up to the
prescribed level.
7. Properly dispose of the used engine oil.
(1) Engine oil filter
1.6.2 Changing engine oil
WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key
before changing the oil.
• Oil can be hot and can burn. Allow the engine to
cool down sufficiently.
BX1880
Engine oil with fil-
ter
Capacity
3.0 L
3.2 U.S.qts
BX2380
Engine oil with fil-
ter
Capacity
3.3 L
3.5 U.S.qts
BX2680
Engine oil with fil-
ter
Capacity
4.0 L
4.2 U.S.qts
1. To drain the used engine oil, remove the drain plug
at the bottom of the engine, and drain the engine oil
completely into the oil pan.
2. After draining of the used engine oil, reinstall the
drain plug.
3. Fill the engine with the new engine oil up to the
upper notch on the dipstick.
4. Properly dispose of the used engine oil.
BX1880 and BX2380
BX2680
BX1880, BX2380, and BX2680
(1) Oil inlet
(2) Dipstick
(3) Drain plug (A) Oil level is acceptable within
this range.
2. GENERAL
CHECK AND MAINTENANCE
1. Periodic service
2-32
BX1880,BX2380,BX2680,RCK60B-23BX,RCK54-23BX,RCK48-18BX,RCK60D-26BX,RCK54D-26BX
KiSC issued 03, 2019 A