(When reassembling)
• Apply grease to the center pin (5).
• Adjust the balancer spring (3) length to the factory
specification, with lock nut (1).
Balancer spring
length (L) (Right
and left)
Factory specifi-
cation
55.0 mm
2.17 in.
8. Servicing
8.1 Adjusting turning torque of
pinion shaft
(1) Adjusting shim
(2) Adjusting shim
(3) Adjusting shim
(4) Blade screw
1. Set the blade screw (4) for the blade shaft to
measure the turning torque.
2. Turn the blade screw (4) clockwise with torque
wrench and measure the turning torque.
Turning torque
Factory specifi-
cation
Less than
0.7 N
⋅
m
0.07 kgf
⋅
m
0.52 lbf
⋅
ft
Thickness of adjusting shims
(1), (2)
0.2 mm
0.0079 in.
0.3 mm
0.0118 in.
Thickness of adjusting shims
(3)
0.2 mm
0.0079 in.
0.3 mm
0.0118 in.
8.2 Adjusting backlash between
bevel gears
(1) Shim
(2) 21T bevel gear
[RCK48-18BX]
19T bevel gear
[RCK54-23BX,
RCK54D-26BX]
18T bevel gear
[RCK60B-23BX,
RCK60D-26BX]
(3) Gear box cap
(4) Shim
(5) Input shaft
(6) Shim
(7) External circlip
1. Remove the gear box cap (3).
2. Place the plastigauges or wire of solder the bevel
gear (2) on the input shaft (5).
3. Turn the input shaft (5).
4. Remove the plastigauges or wire of solder, and
measure the thickness with the gauge or an outside
micrometer.
SERVICING
8. Servicing
9. MOWER
BX1880,BX2380,BX2680,RCK60B-23BX,RCK54-23BX,RCK48-18BX,RCK60D-26BX,RCK54D-26BX
9-25
KiSC issued 03, 2019 A
Содержание ,RCK60B-23BX
