KTM 50 SX 2017, Руководство пользователя

Страница: 71 / 104

13 WHEELS, TIRES
69
H01199-10
Main work
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease the contact surfaces  of the spacers.
Long-life grease ( p. 95)
–
Insert the spacers.
Info
Insert the wide spacer on the left in the direction of travel.
V00281-12
–
Clean and grease wheel spindle  .
Long-life grease ( p. 95)
–
Lift the rear wheel into the swingarm and place the chain on the rear sprocket.
The brake linings are correctly positioned.
–
Insert wheel spindle

with washer

.
–
Position washer  . Mount nut  , but do not tighten it yet.
–
Make sure that the chain adjuster support plates are in contact with the adjusting
nuts.
–
Check the chain tension. ( p. 51)
–
Tighten nut  .
Guideline
Nut, rear wheel spindle M12x1 40 Nm
(29.5 lbf ft)
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 34)
13.5 Checking the tire condition
Info
Only mount tires approved and/or recommended by KTM.
Other tires could have a negative effect on handling characteristics.
The type, condition, and air pressure of the tires all have a major impact on the handling of the motorcycle.
The tires mounted on the front and rear wheels must have a similar profile.
Worn tires have a negative effect on handling characteristics, especially on wet surfaces.
400602-10
–
Check the front and rear tires for cuts, run-in objects, and other damage.
» If the tires have cuts, run-in objects, or other damage:
–
Change the tires.
–
Check the tread depth.
Info
Adhere to the legally required minimum tread depth.
Minimum tread depth
≥
2 mm (
≥
0.08 in)
» If the tread depth is less than the minimum tread depth:
–
Change the tires.