KTM 50 SX 2017, Руководство пользователя

Страница: 63 / 104

12 BRAKE SYSTEM
61
H01198-10
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the front wheel bearing.
–
Clean and grease the contact surfaces

of the spacers.
Long-life grease ( p. 95)
–
Insert the spacers.
H01452-11
–
Clean and grease wheel spindle.
Long-life grease ( p. 95)
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
The brake linings are correctly positioned.
H01451-12
–
Mount and tighten screw

.
Guideline
Screw, front wheel spindle M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
–
Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
–
Correct the brake fluid level.
Guideline
Brake fluid level under top level of con-
tainer 5 mm (0.2 in)
Brake fluid DOT 4 / DOT 5.1 ( p. 93)
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilled brake fluid immediately with water.
–
Remove the motorcycle from the lift stand. ( p. 34)
–
Operate the front brake and compress the fork a few times firmly.
The fork legs straighten.
–
Tighten screws

.
Guideline
Screw, fork stub M6 10 Nm (7.4 lbf ft)
12.9 Checking the free travel of the foot brake lever
Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear brake.
–
Set the free travel on the foot brake lever in accordance with the specification.