KSB Amacan P 1000-700, Инструкция по установке и эксплуатации

Страница: 73 / 132

7 Servicing/Maintenance
73 of 132
Amacan P
6. Attach the crane hook to bail 571 and pull upright motor unit 80-1 including
rotor 818 with bearing and bearing housing 350. ( ð Section 3.2.2, Page 12)
7. Place the pump set on the pump bowl and bellmouth. Fasten it with hexagon
socket head cap screws 914.02. Secure it with a thread-locking agent (Loctite
243).
7.6.4.3 Impeller-end mechanical seal — pump sizes 700-... to 1200-...
932.44
550.44 433.02
Fig. 44: Installing the impeller-end mechanical seal
ü The pump bowl has been fastened to the motor.
ü
The pump set has been positioned horizontally on a wooden support. It has been
secured against rolling off.
1. Use an assembly sleeve of a suitable diameter to press the mating ring of
mechanical seal 433.02 together with the O-ring into the drilled recess in the
pump bowl.
2. Carefully guide on the bellows part of the mechanical seal until it rests against
the mating ring.
3. Slide disc 550.44 and circlip 932.44 onto the shaft. Press the circlip in with an
assembly sleeve until it is axially fastened in the shaft groove.
4. Check the lubricant reservoir for leakage. ( ð Section 7.6.7.1, Page 77)
5. Fill the lubricant reservoir with lubricant. Then close the lubricant reservoir.