Kramer Electronics Ltd.
PA-240Z - Using the Embedded Web Pages
16
Setting Equalization Levels
We recommend that you first set the frequencies, then the Q and finally the gain for the
Bass
Mid
and
Treble
ranges.
To set EQ levels:
1. In the navigation pane click
Speaker Output
. The Speaker Output page appears.
2. In the EQ column set the following:
Set the
Bass
[60Hz, 80Hz, 100Hz or 200Hz]
Mid
[500Hz, 1kHz, 1.5kHz or 2.5kHz]
and
Treble
[10kHz, 12.5kHz, 15kHz or 17.5kHz] frequency.
Set the
Bass
,
Mid
and
Treble
Q-Factor [0.1 to 16].
The lower the Q value, the higher the bandwidth.
Use the sliders to set
Bass
,
Mid
and
Treble
equalization or enter their value below
the sliders.
Setting the Master Volume and Balance
The maximum master volume level of the speaker output is set via the trimmer
on the rear
panel, see
Adjusting the Master Volume
on page
12
.
In the Master Volume column:
Use the slider to set the speaker audio level.
Click
to mute/unmute the output volume.
Set the left right balance on the speaker output.
Setting the Line Level Output Parameters
PA-240Z
enables automatically setting the line level output parameters according to the
speaker output parameters see
Setting the Speaker Output Parameters
on page
15
or setting
them manually via the Line Level Output page.
To set the line level output parameters independently (unlinked to speaker output
parameters):
1. In the Navigation pane, click
Speaker Output
. The Speaker Output page appears.
2. Click
Unlinked
.
3. In the Navigation pane, click
Line Level Output
. The Line Level Output page appears.
