Kramer Electronics Ltd.
PA-240Z - Operating the PA-240Z
12
Operating the PA-240Z
This section describes the following operations:
Setting the DIP-Switches
on page
12
.
Adjusting the Master Volume
on page
12
.
Setting the DIP-Switches
By default, the DIP-switches are set to Hi-Z and 100V.
DIP-Switch #
Setting
Note
1
Set to
Hi-Z
for high impedance configurations.
Use when connecting mono speakers
in daisy-chain.
Set to
Lo-Z
for low impedance configurations.
Use when connecting to a single pair of
speakers, one to the left and one to the
right.
2
When in
Hi-Z
, set either to 70V or 100V according to
your requirements.
Adjusting the Master Volume
Use the VOLUME trimmer
on the rear panel to set the maximum level for the speaker
output speaker output. Adjust the master volume (speaker output) via the web pages, see
Setting the Master Volume and Balance
on page
16
.
