Kramer Electronics Ltd.
PA-240Z - Using the Embedded Web Pages
15
Setting the Speaker Output Parameters
Use the Speaker Output page to set the speaker input signals mixing and the output
parameters.
PA-240Z
enables automatically setting the line level output parameters according to the
speaker output parameters (see
Setting the Line Level Output Parameters
on page
16
).
The Speaker Output Mixer enables performing the following operations:
Mixing the Input Signal Levels
on page
15
.
Setting Equalization Levels
on page
16
.
Setting the Master Volume and Balance
on page
16
.
Mixing the Input Signal Levels
The indication buttons next to Input 1 and Input 2 appear green when there is an active
signal on that input.
To set the Mixing Level:
1. In the Navigation pane, click
Speaker Output
. The Speaker Output page appears.
Figure 15: Speaker Output Page
2. In the
Mix
column, use the sliders to set the mixing level for each input or enter their
value below the sliders.
3. Set the High-Pass Filter
ON
or
OFF
to cut-off frequencies lower than 70Hz.
To save energy, enable the High-Pass Filter when outputting soft background music or vocal
sounds.
