KOZI
D
IRECT
V
ENT
G
AS
S
TOVE
33
1. Open front glass door by following the instructions supplied in the
owner’s manual.
2. Remove the burner assembly by lifting the front edge slightly, and
pull the entire burner assembly forward to release from the orifice
assembly.
3. Remove orifice support bracket and loosen orifice by holding the
brass elbow fitting tight while turning the orifice with a wrench.
4. Remove and replace burner orifice with the replacement supplied in
the conversion kit.
5. Adjust the primary air setting on the burner venturi for the type of
fuel that you are converting to. (Approximately ¼” – NG, ½” – LP)
6. Remove the access panel from the burner prior to replacing into the
unit, as this allows for proper alignment of the burner to the orifice.
Ensure that the burner manifold tube aligns closely to the orifice.
(Loosening of the orifice support might be required, be sure to
tighten again before use.)
7. Test all applicable connections for gas leakage prior to replacing
the access panel.
GAS VALVE REGULATOR
1. Depress and turn gas valve knob to “OFF” position.
2. Remove existing regulator and gasket from control by removing the
two screws. Discard.
3. Install the new RB regulator and gasket with the new screws from
the kit. Tighten the screws securely.
4. Relight the appliance by following the operating instructions.
5. Test for leaks around the regulator using instrument or soap test
solution with the main burner “ON”.
GENERAL NOTES
Be sure to attach the appropriate conversion plate to the inside of the right side panel
indicating clearly all the applicable information.
Check the new regulator for proper operation on both HI and LO settings.
If there are any problems encountered during the conversion, please contact a
KOZI
dealer immediately.
