69
4
© 2017 KOSTAL Solar Electric GmbH
Operation and operating the device
4.10 Event codes
There is no need to take action when an event occurs
occasionally or only briefly and the device resumes
operation. When an event occurs over long periods or
recurs frequently, the cause must be determined and
rectified.
In case of a permanent event, the inverter interrupts the
feed-in and switches off automatically.
n
Check whether the DC switch or the external DC
voltage separator has been switched off.
n
Check whether the event is due to a mains power
failure, or whether the fuse between the feed meter
and the inverter has tripped.
If the fuse has tripped, notify the installer; if there is a
power failure, simply wait until the grid operator has cor-
rected the problem.
If the event lasts only a short time (grid fault, overheating,
overload, etc.), then the inverter will automatically resume
operation as soon as the event has been resolved.
If the event persists, notify your installer or the manufac-
turer's customer support team.
Provide the following information:
n
Device type and serial number. You will find this
information on the type plate on the exterior of the
housing.
n
Description of fault
(LED display and display message).
The type of event can be determined on the basis of
the message in the display "Event code: xxxx" and the
following table.
In the case of events not listed in the table, please con-
tact the Service team.
DANGER
RISK OF DEATH DUE TO ELECTRI-
CAL SHOCK AND DISCHARGE!
Life-threatening voltages are pres-
ent in the inverter. Only a qualified
electrician may open and perform
work on the device.
INFO
You can find contact details in the
chapter "Warranty and service":
2
3
4
6
7
8
9
10
11
1
5
