Korenix JetNet 4500 Series, Руководство пользователя

Страница: 17 / 69

Hardware Installation
Korenix JetNet Series Industrial Managed Ethernet Rail Switch User’s Manual 2-7
DIN-Rail clip is not screwed on the JetNet, follow the instructions and the figure below to attach
the DIN-Rail clip to the JetNet. Here we use JetNet 4508 Industrial Ethernet Switch as an
example.
1. Use the screws to attach the DIN-Rail clip to the rear panel of the JetNet 4508.
2. To remove the DIN-Rail clip, reverse step 1.
Follow the steps below to mount the JetNet to the DIN-Rail track.
1. First, insert the upper end of the DIN-Rail clip into the back of the DIN-Rail track from its
upper side.
2. Lightly push the bottom of the DIN-Rail clip into the track.
3. Check if the DIN-Rail clip is tightly attached on the track.
4. To remove the JetNet from the track, reverse the steps above.
Wall-Mounting Installation
Follow these steps to mount the unit to a wall or other flat surface.
1. Use a screwdriver to remove the two screws that secure the DIN-Rail clip to the back of the