D R A F T — F O R I N
T E R N A L U S E O N L Y
26
www.kontron.com
User Guide
CP3010-SA
The following is an example of the General Purpose LEDs’ operation if the POST configuration is en-
abled (see also Table 7, General Purpose LEDs Function).
Note:
Under normal operating conditions, the General Purpose LEDs should not remain lit during
boot-up. They are intended to be used only for debugging purposes. In the event that a
General Purpose LED lights up during boot-up and the CP3010-SA does not boot, please
contact Kontron for further assistance.
2.7.2 USB Interfaces
The CP3010-SA provides four USB ports:
»
One USB 3.0 port on the front I/O
»
One USB 2.0 port on the front I/O
»
Two USB 2.0 ports on the rear I/O, one of them switchable to the high-speed I/O extension
connector, J7, for the CP3010-HDD extension module
On the front panel, the CP3010-SA has one standard, type A, USB 3.0
connector, J8, and one standard,
type A, USB 2.0
connector, J9.
2.7.3 DisplayPort Interfaces
The CP3010-SA provides two standard DisplayPort interfaces for connection to two monitors. The in-
terfaces are implemented as standard DisplayPort connectors, J3 and J6, on the front panel.
2.7.4 Serial Ports
The CP3010-SA provides two serial ports:
»
COMA available either on the CompactPCI rear I/O connector (3.3V LVTTL) or on the CP3010-
HDD extension module
»
COMB on the CompactPCI rear I/O connector (3.3V LVTTL)
COMA and COMB are fully compatible with the 16C550 controller and include a complete set of hand-
shaking and modem control signals. The COMA and COMB ports provide maskable interrupt generation.
The data transfer on the COM ports is up to 115.2 kbit/s.
Table 10: POST Code Example
LED3
LED2
LED1
LED0
RESULT
HIGH NIBBLE
off (0)
on (1)
off (0)
off (0)
0x4
LOW NIBBLE
off (0)
off (0)
off (0)
on (1)
0x1
POST CODE
0x41
