D R A F T — F O R I N
T E R N A L U S E O N L Y
40
www.kontron.com
User Guide
CP3010-SA
3 Configuration
3.1 DIP Switch Conf iguration
The DIP switch SW1 provides the following switches for board configuration: POST code indication, SPI
boot flash selection, system write protection configuration and uEFI BIOS configuration.
Figure 6: DIP Switch SW1
The default setting is indicated by using italic bold.
To clear the uEFI BIOS settings and the passwords, proceed as follows:
1.
Set DIP switch SW1, switch 4, to the ON position.
2.
Apply power to the system.
3.
Wait 30 seconds and then remove power from the system. During this time period no messag-
es are displayed.
4.
Set DIP switch SW1, switch 4, to the OFF position.
Table 24: DIP Switch SW1 Functionality
SWITCH
SETTING
FUNCTIONALITY
1
OFF
Boot-up with POST code indication on LED3..0
ON
Boot-up with no POST code indication on LED3..0
2
OFF
Boot from the standard SPI boot flash
ON
Boot from the recovery SPI boot flash
3
OFF
Non-volatile memory write protection disabled
(if no other write protection sources are enabled)
ON
Non-volatile memory write protection enabled
4
OFF
Boot using the currently saved uEFI BIOS settings
ON
Clear the uEFI BIOS settings and use the default values
1
3
2
4
O
N
