Kongsberg Simrad MF90, Руководство по установке

Страница: 281 / 426

476671/B
279
Some instruments may provide other parameters and/or options. You must always
check the relevant technical documentation supplied by the manufacturer.
d Select
OK
to save the selected settings and close the dialog box.
6 At the bottom of the page, select
Apply
to save your settings.
7 Repeat for any other communication ports that you need to set up.
8 Continue your work in the
Installation
dialog box, or select
OK
to close it.
Related topics
Setting to work, page 186
Setting up the interfaces to peripheral devices, page 276
Setting up the input from a navigation system (GPS)
For the MF90 system to use and offer correct navigational information, one or more external
sensors must be connected. Typical sensors are those providing navigational information
(heading, speed or geographical position). To select which sensors to install, use the
Sensor
Installation
page. Your current position is shown on the top bar if you have enabled this
in the
Display Options
dialog box.
Prerequisites
This procedure assumes that:
• You have a vacant interface port on your Processor Unit.
• You are familiar with NMEA and other relevant datagram formats.
• You know how to set up the parameters for serial and local area network (LAN)
communication.
• The interface port is set up with the correct communication parameters.
• The MF90 system is turned on and operates normally.
• The new sensor is physically connected to the MF90 system using a serial or network
cable. The sensor is turned on and in normal operation.
Neither tools nor instruments are required.
Context
The
Sensor Installation
page allows your MF90 system to communicate with external
sensors and systems. You must specify which communication port to use (LAN (Local Area
Network) or serial port). You can type a custom name to identify the sensor import. In the
list of valid datagram formats, select the format(s) to be accepted by the MF90 system. For
Setting to work