Kongsberg Simrad MF90, Руководство по установке

Страница: 266 / 426

264
476671/B
Context
Illustrations MF94 :
A Forward (Bow)
B
This is the alignment angle (±180°)
C
0° transducer mark
MF90
The hull unit is fitted with a
label that indicates the forward
(bow) direction. This places the
0° transducer mark at an angle of
approximately 120 degrees on the
port side relative to the bow.
MF94
As a general recommendation,
the hull unit shall be oriented with
the hoisting motor pointing aft. If
this orientation makes it difficult
to access electrical connections,
the hull unit may be rotated during
its installation to the most suitable
direction. Independent of the hull unit orientation, the alignment is always defined as:
The angle measured from the bow to the 0° transducer mark.
The 0° transducer mark is located outermost on the mounting flange, and it is marked
as a red "0". Depending on the transducer mounting, it can be located at any angle on
the mounting flange, not necessarily as shown in the illustration.
On the
Transducer
page, define this angle as rotation around Z .
• If the 0° transducer mark points to the starboard (right) side of the vessel’s centre line,
insert the alignment as a number between 0 and +180 degrees.
• If the 0° transducer mark points to the port (left) side of the vessel’s centre line (as shown
in the illustration), insert the alignment as a number between 0 and –180 degrees.
Simrad MF90 Installation Manual