Kongsberg Simrad MF90, Руководство по установке

Страница: 293 / 426

476671/B
291
7 At the bottom of the dialog box, select
Apply
to save your settings.
8 Continue your work in the
Installation
dialog box, or select
OK
to close it.
Further requirements
If you choose a serial COM port to interface the motion sensor, make sure that you do not
put the same COM port to other use on the
I/O Setup
page.
Note
To align an external motion sensor to the internal sensor, you may need to adjust the
stabilization offset values.
Related topics
Setting to work, page 186
Setting up the interfaces to peripheral devices, page 276
Adjusting the stabilization offsets for the external motion sensor, page 272
Setting up the MF90 system for synchronized operation
If you want to use the MF90 system as a master or slave in a synchronized system, you must
set it up for such operation. To do this, you must select which communication port to use for
the synchronization interface, and you must select the requested synchronization mode.
Prerequisites
This procedure assumes that:
• The vessel is berthed or at sea.
• You have an RS2-232 interface port on your computer that allows you to use the
CTS/RTS connections.
For "slave" operation, a remote system (for example K-Sync or Simrad TU40 ) must be
available to provide trigger pulses. For "master" operation, a remote hydroacoustic system
(sonar, echo sounder) is connected. This remote system must be set up in "slave" mode.
You must be equipped with a standard set of tools. This tool set must comprise the normal
tools for electronic and electromechanical tasks. This includes different screwdriver types,
pliers, spanners, a cable stripper, a soldering iron, etc. Each tool must be provided in various
sizes. We recommend that all tools are demagnetized to protect your equipment.
Context
Whenever more than one hydroacoustic system is installed on a vessel, interference may
occur. To avoid interference, you have these options:
Setting to work